Prestige ELVAT5C Keyless Remote

 

A Prestige keyless door unlocking system is available as an "after-market" option for many makes of automobiles.

The following applies ONLY to the Prestige door unlocking transmitter and receiver system.

When adding or replacing an ELVAT5C remote transmitter the following programming sequence is required to be used.

1. Insert the keys in the ignition and turn the ignition switch from OFF to RUN, five times within ten seconds, ending in RUN. If the vehicle has successfully entered the program mode, it will lock and then unlock all doors automatically.

2. Press ANY button on the keyless entry remote transmitter and the doors will lock and then unlock to confirm that this particular  keyless entry remote transmitter has been activated. NOTE: When the first keyless entry remote transmitter is programmed, all previously existing keyless entry remote transmitters are erased. Therefore EACH transmitter which was successfully used previously must now be re-programmed!

3. Repeat the previous step for each transmitter that will be used to operate the vehicle's door locks and alarm system.

4. If the door locks do not respond for any particular keyless entry remote transmitter, wait 10 seconds and press the button again.

(The transmitter operates on a frequency of 302.00 Mhz.)

Brought to you as a public service by:

 

Hit Counter